Click a category to filter the related parts shown. Not all parts apply to all models, so always check the Product Description before ordering.
- Arm Restraints - Cables, Chains, Pulleys - Locks - Hydraulic Cylinders - Hydraulic Power Units, Controls - Door Pads - Vehicle Adapters, Extensions -
Lock release AIR CYLINDER for carraige locks on Challenger brand 2-post lifts including models 37000, 39000, 70000 and others. Also for some Challenger built Ammco brand lifts.
Does not include clevis for mounting to lock pawl, air fitting, or mounting...
Arm restraint assembly kit and hardware.
Used on many older Challenger two-post lifts. Also some Challenger built Ammco brand lifts.
OEM / Aftermarket Equivalent: BH-7226-25, BH-7225-55, 200308, 31052.
ProblemSolver! Complete replacement hydraulic POWER UNIT for most lifts or hoists. Includes hydraulic tank, pump, motor & switch.
208-230 volt single phase. 60 hz.
2.5 hp dual capacitor motor.
Easily replaceable cartridge...
ProblemSolver! Complete replacement hydraulic POWER UNIT for most lifts or hoists. ETL Certified. Includes hydraulic tank, pump, motor & switch. Stone (Fenner) brand. Assembled in the USA. This unit has a "cable pull" high limit kill switch...
Equalizing Cable for Challenger model X10.
Dimensions: 33' 9" (405") long
OEM / Aftermarket Interchanges: BH-7234-23, X10-094.
Cable may vary slightly from illustration.
BREATHER CAP for newer Stone brand Power Units. Fits our 5141-AC.
OEM / Aftermarket Interchanges: 260185, BH-7005-21 .
BREATHER-CAP for many hydraulic power unit oil tanks.
OEM / Aftermarket Interchanges: BH-7004-30, 8060-CC.
Power unit CHECK VALVE CARTRIDGE for many Fenner, SPX, and Stone brand power units (may fit others as well). This is one of 3 valves that must be functioning properly or the lift may "leak down" or settle (the other valves are the Lowering Valve and the...
Voltage/HP ratings: 30 amp; Motors up to 3HP/240volt , 1.5hp/124volt
Start capacitor disconnect CONTACTS assembly for many capacitor start power unit motors. Also known as the STATIONARY SWITCH for the capacitor circuit on capacitor start motors. This switch is only used on 3450 RPM motors.The most common symptom of a bad...
Splined Motor to Pump COUPLER for some SPX, Fenner, Stone Hydraulic Power Units.
OEM / Aftermarket Interchanges: 2181-BA, BH-7006-14.
Slip-on 6" height extension for Challenger brand lift models: CL9, CL10, X10, VS10, & E10.Also fits some in-ground Challenger model CS9200 lifts.Includes replaceable rubber pad.(view)OEM / Aftermarket Equivilants: 10303, BH-7232-00.